Sunday, July 11, 2010

Ways of Making a Car Spin



(1). Drive straight at approx. 50 km/h (30 mph)if on pavement. Observe your reverse parking sensor system
,On dirt you need to go about half that, preferably in 2nd gear with full throttle.
(2). Remove your right foot from the throttle sharply. On an automatic transmission lightly
touch the brake together with your left foot, while keeping the right foot over the throttle.
(3). Sharply turn the steering wheel in the desired direction.
(4). A moment after the beginning of the steering pull the handbrake while holding the safety
button together with your thumb. Continue steering until your steering wheel is locked. This is much
simpler on cars equipped with power steering, Check your back up camera for caras you need to steer using one hand.
(5). As soon as the tail slides (this is perceived as a moment of weightlessness), step on the
gas.
(6). When you need to exit the spin, straighten the wheel and release the handbrake. In the event you
release the handbrake first, your automobile will cease spinning and start turning normally, possibly
hitting the curb or driving off the road!

2. High-powered RWD

(1). With the automobile at standstill, turn the steering wheel all the way to the desired direction.
(2). Shift in 1st, apply full throttle and release the clutch halfway. This ought to lead to a
wheelspin as well as a tail-happy behavior of your automobile.
(3). When you need to exit the spin, take off the gas while simultaneously releasing the clutch
and straightening the steering wheel.

3. Low-power RWD

(1). Start from rest and start making circles, choose a rear parking mirrorwhile turning the wheel to make the radius
progressively smaller.
(2). As soon as your steering wheel is locked, increase the speed until you feel the automobile cannot
take any more speed without losing control. You must be going in an ideal circle, without any
understeer (i.e. tendency of the front wheels to keep moving straight than turning).
(3). Press the clutch and pull the e-brake.
(4). As soon as the tail slides, release the handbrake and make a wheelspin like described
above.
5. For exiting the spin, see the above procedure.


4. AWD

1. Same as RWD.
2. You ought to keep away from doing it on dry asphalt as it strains your middle differential. Try snow or dirt in lieu.

more about parking sensor,visit: http://global-electronic.blogspot.com/

No comments:

Post a Comment